Annovi Reverberi RS Serie Notice D'utilisation Et Installation page 34

Starting and stopping the pump when supplied by an auxiliary pump
To start the pump, proceed as described below.
1) Open the shut-off valve (J).
2) Open the by-pass
depressurise the delivery pipeline.
3) Start the auxiliary pump (C).
4) Start the pump (D) and run it for a few
minutes with no pressure.
5) Adjust the by-pass valve (G) to obtain
the pump's operating pressure.
To stop the pump, proceed as described
below.
1) Open the by-pass valve (G) to discharge
the pressure.
2) Stop the pump (D).
3) Stop the auxiliary pump (C).
4) Close the shut-off valve (J).
English
INSTRUCTIONS FOR USE
valve (G) to
UN003406-CV
34
6
Use and Installation