Inspect/Dump & Initialise - Stanley Compulevel Manuel D'utilisation

47855 CompuLevel
Inspect/Dump and Initialise
INSPECT or DUMP
This function allows inspection of previously gathered measurement data
and/or data transfer to a PC.
To use this function:
• Momentarily press the CAL and REC keys together to dump data to PC.
• Press and hold CAL and REC keys together for two seconds to inspect
data.
• Momentarily press the MARK key to sequence up through positions.
• Momentarily press the REC key to sequence down through positions.
• To sequence up or down in multiples of ten positions, momentarily
press the CAL key for up and the HOLD key for down.
INITIALISE
This function resets all user settings to default values (COMPULEVEL
must be re-calibrated in this case, see calibration on page 11). This
function also returns the user from any function to the normal display
function.
Note: This is a sure way to recover from an unwanted function.
To INITIALISE:
Press and hold the CAL, REC, MARK and hold keys together for two
seconds using two fingers of each hand with the measurement module on
its back on a flat surface.
Press CAL and REC two seconds to
enter or exit INSPECT
INSPECT/
DUMP
Click CAL and REC momentarily and
release to DUMP DATA to PC
CAL
TENS
Serial – link
19 • Compulevel TM Measurement system
6/11/07 11:14
REC
Sequence
down
ONES
INSPECT POSITION CONTROL KEYS
Pocket PC or...
Palmtop mounted to unipod or held in left hand with
display visible operator
RECORDING DATA 'ON THE FLY'
When COMPULEVEL TM registers fill, 'FULL' will display
but record date to PC can continue indefinitely.
Page 19
MARK HOLD
Sequence
up
ONES TENS
TM