Publicité
Les langues disponibles
Les langues disponibles
Automatic Icemaker
Not all features are on all models.
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40 and
120 psi (275-827 kilopascals).
CAUTION
Avoid contact with the moving parts
of the ejector mechanism, or with the heating element
(located on the bottom of the ice maker) that releases
automatic ice making mechanism while the refrigerator is
plugged in.
A newly-installed refrigerator may take 12–24 hours to
begin making ice.
The ice maker will produce approximately 70-100
compartment temperature, room temperature, number of
door openings and other use conditions.
When the refrigerator has been connected to the water
supply, set the switch ON position.
(-9°C). A newly-installed refrigerator may take 12 to 24
hours to begin making ice cubes.
Once the ice maker starts to make ice, it may take up
to 48 hours to fill the bin, depending on the temperature
settings and number of door openings.
fills with water.
NOTICE: Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
When the bin fills to the level of the feeler arm, the ice
maker will stop producing ice.
cloudy, taste stale, shrink or fuse together.
an automatic ice maker, an ice maker accessory kit is
available at extra cost.
This refrigerator will accept accessory icemaker kit
assembly.
49-1000249 Rev. 0
(on some models)
Power Switch
IMPORTANT: This refrigerator requires a red label
icemaker. See above for the location of the label on the
please call 800.GE.CARES (in Canada 800.561.3344)
for the correct icemaker.
7
Publicité
