Functions - CBE PC210-ST Instructions D'emploi

FUNCTIONS

CAR BATTERY ALARM (B1)
When car battery voltage gets under 12V, car
Battery Discharge alarm goes on and the symbol
ref. 3 starts blinking. Alarm goes off when the
voltage gets over 12.5V.
LEISURE BATTERY ALARM (B2)
When leisure battery voltage gets 11.5V the Leisure
Battery Reserve alarm goes automatically on, the
symbol ref. 4 starts blinking and you hear a short
beep.
When the leisure battery voltage gets 10.5V, the
Leisure Battery Discharge alarm goes automatically
on, the symbol ref. 4 starts blinking and you hear
two short beeps. Alarms go off when the voltage
gets over 12.5V.
MINIMUM VOLTAGE CONTROL (BATTERY
PROTECTION)
The electronic battery protection device cuts off the
12V users when leisure battery reaches 10V and
disables: pump, lights, awning light
Symbol ref. 12 is the visual alarm signal.
It is possible to reactivate all users for one minute
by pressing the on/off button (ref.
panel) .
The control panel automatically turns off with a
voltage lower than 9.5V.
Users are automatically reactivated when voltage is
bigger than 13.5V.
This device doesn't control the functions: fridge,
step and the auxiliary exit (direct B2)
TANKS
a) Fresh water tank with electronic probe: levels are
displayed numerically in % (steps of 10%) and
graphically by the level guage ref. 2.
b) Waste water tank with screw probe.
FRESH WATER TANK REFILLING
T his function is used during the
and indicates the water level during refilling.
To activate this function press the "test tank" button
ref.3 for more than 4 seconds, until the "water
refilling" is displayed on the screen.
The control panel beeps in order to warn that tank
, and stove.
1 on control
fresh water refilling
is getting filled: one short beep at 75%, two short
beep at 85% and a long beep at 95%.
T o exit this function press buttons ref.
FRESH WATER TANK ALARM
A larm turns on when fresh
1 % of the tank capacity and automatically turns off 0
when level exceeds 20%.
Alarm is shown acoustically (when engine is off)
and visually with the symbol ref.
WASTE WATER TANK ALARM
Alarm turns on when the waste water level exceeds
the screw sensor level.
Alarm is shown acoustically (when engine is off)
and visually with the symbol ref. 11 blinking.
AWNING LIGHT AUTOMATIC TURN OFF
An electronic device switches off the awning light
when engine is turned on.
TEMPERATURE
- Both int. and ext. temperatures
sensor placed inside s
- The precision of the temperature value is ± 1°C.
2 or . 3
water level is lower than
10 blinking .
are measured by
and outside of the vehicle.
EN
17