König Electronic IR-URC33 plus Mode D'emploi page 2

Operation:
The 4/8-in-1 universal remote control is suitable for all TV sets (TV), DVD
players (DVD), digital and analogue satellite receivers and cable receivers
(CBL/SAT), video recorders (VCR), tuners (TUNER), CD players (CD), cassette
recorders (TAPE), amplifiers and other audio devices (AMP) from common
manufacturers. The universal remote control can execute almost all basic device
functions.
Button description
Some button functions may be different for different models.
SET - For setting the remote.
TV, VCR, CBL/SAT, CD, DVD, TUNER, TAPE, AMP – Device button
Power – On and Off
0-9 - Number buttons for selecting channels or entering the device code during
setup.
AV/TV - TV/Video button on your TV remote control or the TV/SAT button on
your SAT remote control or A/B in cable and CD mode.
Menu - Menu or OSD (On-Screen Display) or memory.
CH + /- - Channel up and down
VOL +/- - Volume up and down
Mute – Mute the sound
REW (fast reverse)

► PLAY (operate your DVD, CD etc)
FFWD (fast forward)

REC (Record)

STOP (terminate your operation)

PAUSE

Red, Green, Yellow and Blue for TV Teletext.
Television video
TV and text mixed
Teletext mode
Page hold
Displays info on the selected channel
Up, Down, Left, Right, OK, Exit -- Functions like the UP, DOWN, LEFT, RIGHT,
OK, EXIT, menu functions.
Setup
Make sure that fresh batteries have been inserted correctly into the remote
control.
To make your remote control ready for use, you need to carry out one of the
following steps:
A. Setup by Brand Code
1. Switch on the device for which you wish to use the remote control.
2. Find the code number of your device brand in the code list from the
respective device group.
3. Press the SET button and the device button at the same time.
Release the two buttons as soon as LED lights up.
4. Enter the 3-digit device code within 10 seconds. If no entry within 10
seconds, the setup mode is automatically terminated.
5. The LED turns off if the code has been accepted by the remote control. If
the LED flashes twice, that means the code may be wrong, and the remote
control remains in setup mode, enter the correct code from the list again in
good time.
6. Check the function of the buttons on remote control. If it does not function
correctly, try another 3-digit device code (e.g. 010...) from the list under the
ENGLISH
2