Beper BP.961 Mode D'emploi page 8

Automatic pot stirrer Use instructions
Place the product so assembled on the pan and adjust it to the diameter of the pan (can be suitable to pots with a
diameter from 15 up to 25 cm). At this point, press on the pliers placed under the brackets to fix the product to the
pan. Instead, being the axel movable will automatically adapt to the height of the used pot (from 10 up to 20 cm).
At this point press the ON / OFF button to activate the stirrer.
The product will start to mix at the speed set during the last use.
To adjust the speed, use the button with the arrows placed next to the power button.
If during the operation the red light accompanied by an acoustic signal will lights up, it means that the battery is
running low. Turn off the product and charge it again.
To switch off the product, press the ON / OFF button again.
To remove the product from the pot, press on the pliers placed under the brackets and lift it, paying attention to
the central axel that is movable and may fall. Take care that the axle has remained in contact with the food, so it
will be very hot, so it is recommended to use the proper precautions.
Cleaning and maintanance
Clean the motor body with a soft cloth slightly moistened with water. Do not immerse in water or other liquids.
Do not wash in the dishwasher.
The brackets, the stirrer blades and the axle (after having disconnected it from the motor body) can be washed
in warm water and neutral liquid soap or in the upper basket of the dishwasher paying attention to set a tempe-
rature not higher than 60 ° C.
Technical data
Power: 4,2VDC - 5W lithium battery
Power supply: AC 110-240V ~ 50/60Hz- 0,3A
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
8