Beper BP.961 Mode D'emploi page 7

EN
Automatic pot stirrer Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Description Fig.A
1. Motor housing
2. Brackets
3. Axle
4. Stirrer Blades
5. ON/OFF button
6. Speed control button
Some warnings
This product is not a toy so it is recommended to keep it away from children especially when the product is in use.
Do not move the pan by using the mixer handle.
Connect the product to the power supply only for the time necessary for charging. The battery is subject to
discharge if the product is not used for long periods; leaving the product connected to the power supply will not
prevent this issue.
When the product is running low, it will beep. To stop the acoustic signal, recharge the product, otherwise there
will be the risk of compromising the proper use of the battery.
If by selecting the minimum speed, the product will not work well add a little liquid (water, milk, broth) to the
mixture or increase the speed.
It could be that during the first uses the engine noise is slightly strong, it will decrease after some uses.
Remove the mixer from the pan immediately after use to avoid damaging the plastic parts.
Be careful not to drop the mixer on the floor or other hard surfaces to avoid damaging it.
Do not use the mixer in the oven.
Make sure that the flame of the stove does not touch the mixer (this could happen if you use very low pans).
Do not switch on the product without food inside the pan.
When using the mixer it is advisable to keep always the flame low.
Battery charge
To charge the battery, insert the charger pin into the appropriate slot on the back of the motor housing. The inlet
is protected by a small rubber square, pull the square down and insert the charger pin.
A red light will come on to indicate that the product is charging.
When the product is fully charged, the light will turn green.
The charging time is approximately 4 hours.
When fully charged the product will work for about 2 hours. The operating time will depend on the consistency
of the food to be mixed.
Assembly and use of the product Fig.B
Place the motor housing on the central part of the brackets and turn it anticlockwise until it is completely locked.
To be assembled correctly, the motor housing must be perfectly in line with the brackets.
Insert the axle into the stirrer blades and then into the central part of the brackets.
7