Publicité
Les langues disponibles
Les langues disponibles
STEP 2: Prepare The Venting System
NOTE: The ductwork you need for outside ventilation is not included with your oven. The standard ductwork
fittings and length are shown in Figure 9, page 10.
W A R N I N G - F I R E H A Z A R D
You may vent your oven in one of three ways. However, do NOT vent into a wall cavity, an attic, or an unused
area.
Roof-venting If your oven is located on an outside wall near the roof, as in Figures 6 (3 1/4" x 10" duct) and
Figure 8 (6" round duct.)
Wall-venting
If your oven is located on an outside wall of your house, as in Figure 5 (3 1/4" x 10" duct) and
Figure 8 (6" round duct.)
Room-venting If your oven is located on an inside wall of your house, as in Figure 7.
NOTE: If you choose the rear exhaust method (roof-or wall-venting), be sure there is enough clearance within the
wall for the exhaust duct.
Wall Venting
cabinet
oven
Wall venting
REMEMBER AS YOU INSTALL THE
VENTING:
Keep the length of the ductwork and the number
of elbows to a minimum to ventilate your oven
efficiently. See examples on page 10.
Keep the size of the ductwork the same.
Do not install two elbows together.
Use duct tape to seal all joints in the duct system.
Use caulking to seal the exterior wall or roof
opening around the cap.
THIS OVEN MUST BE PROPERLY VENTED!
wall cap
3 1/4"x10"
through-the-wall
duct
Figure 5
cabinet
oven
Roof
venting
Room Venting
cabinet
oven
Figure 7
9
Roof Venting
roof cap
3 1/4"x10"
duct
through-the-roof
Figure 6
roof cap
6"min diameter
round duct
elbow
3 1/4" to round
duct transition
3 1/4" to round
ductwork transition
Figure 8
wall cap
Publicité
