RedMax BCZ230S Manuel D'utilisation page 6

1. Push the throttle trigger lockout (A) and make sure
that the throttle control is released (B).
B
2. Release the throttle trigger lockout and make sure
that the throttle control is locked at idle speed.
3. Push the throttle trigger lockout and make sure that it
goes back to its initial position when you release it.
4. Make sure that the throttle control and throttle trigger
lockout move freely and that the return springs
operate correctly.
5. Start the product and apply full throttle. Refer to
start the engine on page 9 .
6. Release the throttle control and make sure that the
cutting attachment stops. If the cutting attachment
rotates with the throttle in the idle position, do a
check of the carburetor adjustments. Refer to
adjust the idle speed on page 13 .
6
A
To
To
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops. To see where the stop
switch is on your product, refer to
on page 2 .
WARNING: The stop switch
automatically goes back to start position.
To prevent accidental start, remove the
spark plug cap from the spark plug when
you assemble or do maintenance on the
product.
To do a check of the cutting attachment guard
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
prevents injuries that occur if you touch the cutting
attachment. To see where the cutting attachment guard
is on your product, refer to
1. Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
damaged.
To do a check of the vibration damping system
WARNING: Use of incorrectly wound cord or
an incorrect cutting attachment increases
the level of vibration.
The vibration damping system decreases vibration
between the engine unit and the shaft unit, which makes
the operation easier. Refer to
2 to see where the vibration damping units are on your
product.
1. Stop the engine.
2. Do a visual check for deformation and damage, for
example cracks.
3. Make sure that the vibration damping units are
attached correctly.
To do a check of the muffler
The muffler keeps noise levels to a minimum and sends
exhaust fumes away from the operator.
• Do a visual check for damage and deformation.
• Make sure that the muffler is correctly attached to
the product.
Product overview
Product overview on page 2 .
Product overview on page
1558 - 003 - 01.10.2020