EarthQuaker Devices Time Shadows Mode D'emploi page 7

Since the switching is relay-based, it requires power to
pass signal.
POWER REQUIREMENTS
Current Draw .................... 75 mA
This device takes a standard 9 volt DC power supply with
a 2.1mm negative center barrel. We recommend using
a pedal-specific, transformer-isolated, wall-wart power
supply or a power supply with multiple isolated-outputs.
Pedals will make extra noise if there is ripple or unclean
power. Switching-type power supplies, daisy chains and
non-pedal specific power supplies do not always filter
dirty power and may result in unwanted noise.
DO NOT RUN AT HIGHER VOLTAGES! YOU
HAVE BEEN WARNED.
TECH SPECS
Input Impedance .............500 kΩ
Output Impedance .............100 Ω
WARRANTY
This device has a limited lifetime warranty. If it breaks,
we will fix it. Should you encounter any issues, please
visit www.earthquakerdevices.com/support.
7