EarthQuaker Devices Time Shadows Mode D'emploi page 6

GLOBAL FEATURES
Time Shadows has two operating modes which are indicated
by the color of the Save/Recall switch.
GREEN = LIVE MODE
The pedal will operate exactly where the
controls are set, and any changes will have
no effect on the presets unless saved. The
Save/Recall switch will stay static green.
RED = PRESET MODE
Time Shadows will operate in a stored preset
mode which is selected by the preset switch
and the physical settings of the control will
be ignored. The Save/Recall switch will stay
static red.
TIME SHADOWS COMES FACTORY SET TO
START UP IN LIVE MODE.
USER-ASSIGNABLE EXPRESSION CONTROL
Use any TRS expression pedal to take control over the
Time, Span or Filter! Time Shadows ships with the EXP
jack mapped to the Span control. Follow these steps to
reassign the EXP functionality:
Follow these steps to reassign the EXP functionality
1. Insert the expression pedal TRS plug into the EXP jack.
2. Place the expression pedal in the toe down position.
3. Turn the panel control on the Time Shadows that you wish
to put under control of the expression pedal. It doesn't
matter how far or which direction you turn the control.
6
4. Put the expression pedal in the heel down position.
5. This control is now assigned to the EXP jack and can
be used with an expression pedal!
Helpful expression assignment tips
• If you turn the control that is assigned to the EXP jack
while the expression pedal is plugged in, the panel control
will override the expression pedal setting. The expression
pedal will reassume control the next time it is used.
• Different EXP assignments can be saved in each preset.
• You can use Control Voltage with the EXP jack! The CV
range is 0 to 3.3v.
TRS expression pedal wiring
Tip ...................................... Wiper
Ring ...................................+3.3V
Sleeve ..............................Ground
FLEXI-SWITCH TECHNOLOGY
®
This device features Flexi-Switch Technology! This
relay-based, true bypass switching style allows you to
simultaneously use momentary and latching-style switching.
• For standard latching operation: Tap the footswitch
once to activate the effect and then tap again to bypass.
• For momentary operation: With the effect off, hold the
footswitch down for as long as you'd like to use the effect.
Once you release the switch, the effect will be bypassed.
NOTE: HOLDING THE BYPASS SWITCH DOWN
WHILE TIME SHADOWS IS ACTIVATED WILL
SWITCH INTO THE SELECTED PRESET MODE!