Publicité
EN
TECHNICAL DATA
Minimum dynamic pressure: 0.5 bar
Maximum operational pressure: 5 bar
Recommended operational pressure: 1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature: 80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fine in time, must ensure compliance with the mode of
installation and maintenance described in this booklet. Relying on a qualified plumber. Make sure that the
system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Make two holes on the support surface for the handles MIN Ø28 mm - 1.1 in, MAX Ø35 mm - 1.37
in. Mount the fastening set on the pedestal. Insert the post into the hole from under the top, Screw the
bell onto the post, positioning the gasket. Engage the handle and adjust the correct height of the bell by
unscrewing or screwing it. Attach the fixing set. Fix the handle with the screw, and screw the cover plate..
Fig. 2: Connect the hoses to the posts.
Fig. 3: Make the hole for the shower support on the support surface MIN Ø28 mm - 1.1 in, MAX Ø35 mm -
1.37 in. Insert the shower support fixing it with the appropriate fixing kit. Screw the hose to the shower and
insert the end into the support itself.
Fig. 4: Make the hole for the diverter MIN Ø28 mm - 1.1 in, MAX Ø35 mm - 1.37 in on the support surface.
Mount the fixing set on the diverter. Insert the diverter into the hole from under the hob, Screw the bell
onto the diverter, positioning the gasket. Engage the handle and adjust the correct height of the bell by
unscrewing or screwing it. Attach the fixing set. Fix the handle with the screw, and screw the cover plate.
Fig. 5: Screw the T-piece onto the diverter at the outlet for the mouth marked with the sign V. Screw the
reductions for the flexible shower head onto the diverter, at the shower outlet marked with the sign D. Use
hemp or PTFE to ensure tightness.
Fig. 6: Connect the mouth hoses to the T-fitting. Connect the shower hose to the previously connected
reductions. Connect the hoses of the uprights to the two inlets, as shown in the figure.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap unit operates
correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and dry them
with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid detergents which
contain corrosive or acidic substances, abrasive sponges, swab with metallic strings because they could
irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE IB
RUBINETTERIE FROM ANY WARRANTY OBLIGATION.
Publicité
