Electrical Safety - elem Garden Technic TDE1232P Traduction Des Instructions D'origine

ELECTRICAL SAFETY

Always check that
corresponds to the
voltage on the
plug from mains before adjusting,
cleaning or if cable is cut,
damaged or entangled.
for a few seconds after the
machine is switched off.
– do not touch the
rotating blade.
Your machine is double insulated
for safety and requires no earth
connection. The operating
voltage is 230 V AC, 50 Hz (for
non-EU countries 220 V, 240 V
as applicable). Only use
approved extension cables.
Contact your ELEM GARDEN
TECHNIC Service Centre for
details : sav@eco-repa.com
Extension cords/leads should
only be used if they comply with
H05VV-F, H05RN-F types or IEC
type design (60227 IEC 53,
60245 IEC 57).
If you want to use an extension
cable when operating your
product, only the following cable
dimensions should be used:
– 1.0 mm²: max. length 40 m
– 1.5 mm²: max. length 60 m
– 2.5 mm²: max. length 100 m
Note: If an extension cable is
used it must be earthed and
connected through the plug to the
earth cable of your supply
the power
supply
rating plate.
network in accordance with
prescribed safety regulations.
If in doubt contact a qualified
electrician or the nearest ELEM
GARDEN TECHNIC Service
Centre / sav@eco-repa.com
extension cables can be
dangerous. Extension cable, plug
and socket must be of watertight
construction and intended for
outdoor use.
Cable connections should be
kept dry and off the ground.
It is recommended for increased
electrical safety to use a Residual
Current Device (RCD) with a
tripping current of not more than
30 mA. Always check your RCD
every time you use it.
The connection lead must be
inspected for signs of damage at
regular intervals and may only be
used if in perfect condition.
If the supply cord is damaged, it
must be replaced by a ELEM
GARDEN TECHNIC Service
Centre / sav@eco-repa.com
34