Publicité
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, that may cause
undesired operation.
Warning: Changes or modifications to the equipment not approved by Peavey
Electronics Corp. can void the user's authority to use the equipment.
Note - This equipment has been tested and found to comply with the limits for
This equipment has been tested and found to comply with the limits for a Class A digital device,
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
against harmful interference when the equipment is operated in a commercial environment. This
radio frequency energy and, if not installed and used in accordance with the
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
instructions, may cause harmful interference to radio communications. However,
accordance with the instruction manual, may cause harmful interference to radio communications.
there is no guarantee that interference will not occur in a particular installation. If
Operation of this equipment in a residential area is likely to cause harmful interference in which case
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
the user will be required to correct the interference at his own expense.
encouraged to try and correct the interference by one or more of the following
measures.
Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can
void the user's authority to use the equipment.
FCC Compliancy Statement
FCC Compliancy Statement
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian, MS • 39305
(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com • 80305796 • ©2011
Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian, MS • 39305
(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com • 80305796 • ©2011
CAN ICES-3 B/NMB/3B
20
Publicité
