Publicité
Les langues disponibles
Les langues disponibles
automatically switch off when disconnected from a device.
N To comply with FCC/IC RF exposure compliance requirements, the wireless
charger must be used with a separation distance of at least 20 cm from all
persons.
N This device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
N Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
SAVE THESE INSTRUCTIONS
Legal
Manufacturer shall not in any way be liable to you or to any third party for any
damages you or any third party may suffer as a result of use, intended or unintended,
or misuse of this product in conjunction with any device or accessory other than the
appropriate device for which this product is designed. Manufacturer will not be
responsible for any damages you or any third party may suffer as a result of misuse
of this product as outlined above. Purchaser agrees to defend, indemnify, and hold
Manufacturer harmless for any claims or damages arising from unintended use or
misuse, including use with an unintended device.
USB-C is a trademark of USB Implementers Forum. All rights reserved.
This device complies with part 15 of the FCC Rules and RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced technician for help.
CAUTION: To comply with the limits of the Class B digital device, pursuant to
Part 15 of the FCC Rules, this device must be used with certified peripherals and
shielded cables. All peripherals must be shielded and grounded. Operation with
non-certified peripherals or non-shielded cables may result in interference to radio
or reception.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
7
Publicité
