Zibro S13 Serie Manuel D'installation page 73

instal_S(C)13xx.qxd 06-05-2010
Drain joint installation
(see fig. 14)
Fit the seal into the drain elbow, then insert the drain joint into the base pan hole in the bottom of the out-
door unit, rotate 90° to assemble them securely. Connect the drain joint with an extension drain hose (not
included). In this way condensed water, which is produced during heating mode of the airconditioner, can
be drained away.
Fig. 14
For SC13xx models
< 20 < 20
cm cm
REFRIGERANT PIPING CONNECTION
ATTENTION
All refrigerant work and refrigerant piping should comply with the local legislation, standards
and codes and should only be done by qualified and skilled people.
CAUTION
For your safety, always wear safety eye wear and work gloves when connecting the pipes.
11:41 Pagina 73
All manuals and user guides at all-guides.com
Drain joint
Seal
Base pan hole of
outdoor unit
The last 20 cm of the
refrigerant pipe, close to
the connector must be
kept straight. Bending can
cause leakage and is not
covered by the warranty.
≥ 20 ≥ 20
cm cm
Seal
Drain pipe
Fig. 15
4
73