Publicité
Les langues disponibles
Les langues disponibles
Desk-clamp mount
Step A: Determine the thickness of the mounting surface, then use the 4 mm Allen wrench to
adjust the location of the mounting clamp assembly, if necessary.
• The top screw holes on the clamp bracket fit a mounting surface thickness of less than
5/8 in. (1.6 cm).
• The middle screw holes on the clamp bracket fit a mounting surface thickness between
1/2 to 1 5/8 in. (1.2 to 4.1 cm).
• The bottom screw holes on the clamp bracket fit a mounting surface thickness between
1 1/4 to 2 5/8 in. (3.2 to 6.7 cm).
4 mm Allen wrench
< 0 to 5/8 in.
(0 to 1.6 cm)
Step B: Slide the mounting clamp assembly onto the mounting surface, then tighten the
clamp.
6
1/2 to 1 5/8 in.
(1.2 to 4.1 cm)
Caution: Do not rotate the monitor past
the edge of desk. The weight of the
monitor may cause the desk to tip over.
1 1/4 to 2 5/8 in.
(3.2 to 6.7 cm)
Publicité
