Publicité
Les langues disponibles
Les langues disponibles
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
Owner's Record
The model and serial numbers are located on the
bottom. Record the serial number in the space
provided below. Refer to these numbers whenever
you call upon your Sony dealer regarding this
product.
Model No. CPJ-200
Serial No.
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
RISK OF ELECTRIC SHOCK
80 NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USEA-SERVICEABLE PARTS iNSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
AN
AN
This symbol is intended to alert the
user to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
For the Customers in the U.S.A.
WARNING
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This
equipment generates, uses, and can radiate radio
trequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interterence to radio communications.
However, there
is no guarantee thal interference will not occur ina
particular installation.
If this equipment does cause
harmtul interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
~ Increase the separation between the equipment and
receiver,
- Connect the equipment inte an outlet on a circuit
different from that to which the receiver is
connected.
~ Consult the dealer or an experienced radio/TV
technician for hetp.
~ CAUTION
You are cautioned that any changes or modifications
not expressly approved in this manual could void
vour authority to operate this equipment.
es)
Projecting (See illustration E].)
1 Connect the AC plug to a wall outlet.
2 Set the POWER switch to ON.
The POWER lamp lights green.
3 Play back a tape on the video equipment.
Refer to the instruction manual of the video
equipment.
4 Adjust the projecting angle.
@ Set the PROJECTION LOCK switch up.
© Adjust the lens angle.
© Set the PROJECTION LOCK switch to LOCK.
5 Adjust the picture.
Adjust the focus by turning the FOCUS ring. [a]
Adjust the brightness with the PICTURE control.
[b}
Press WIDE to select the picture mode between the
normal mode and the wide mode*. [c]
The WIDE lamp lights red when the wide mode is
selected.
6 Adjust the volume by pressing VOLUME +/-.
The display indicates for about 5 seconds on the
screen after the button is pressed.
* In the wide mode, the hight of the picture is
shortened and the picture is compressed in the
vertical direction. The ratio of hight to width of the
picture becomes 9:16.
To enjoy a clearer picture
¢ Place the unit so as to make the lens perpendicular to
a projected plane, otherwise the picture becomes
distorted and may be out of focus.
¢ Use the unit in a dark place so that the picture is
projected clearly.
* Do not subject the projected plane to direct light such
as a room light.
¢ The brightness of picture differs in accordance with
the quality of surface of a wall or screen and size of
the projected plane. Adjust the brightness
accordingly with the PICTURE control.
¢ In adjusting the height, an optional Sony tripod is
recommended.
Caution
Be sure to use the house current as a power source of
your projector to prevent damage and accidents.
Never use a DC/AC converter.
Notes
¢ If the picture does not appear for more than five
minutes, the power is turned off. To turn on the power
again, set the POWER switch to OFF and then ON.
* Be sure to disconnect the AC plug from a wall outlet
when not using this unit.
¢ While projecting, the corners of a picture may be dark.
¢ There is a fanin the unit for protection from dust and
heat. When using the unit, the sound of the fan motor
can be heard.
This is not malfunction.
Publicité
