weinor BiSens SW-230V Instructions De Montage page 12

Technical data
Power supply
Temperature range
Detection angle (light sensor)
Degree of protection
Radio frequency
Power consumption
A special version ist available for United States, some countries
from south america, Canada and Australia.
Maintenance
The BiSens SW-230V must be freely accessible and must not be
overgrown by vegetation.
The BiSens SW-230V is maintenance-free, however the cover
must be cleaned from time to time using a moist cloth.
weinor Mathias-Brüggen-Str. 110
GmbH & Co. KG D-50829 Cologne
All manuals and user guides at all-guides.com
230 V / 50 Hz
-25 °C to +60 °C
150 °
IP 43
868 MHz frequency band
typical 1.5 W
Phone: +49 221 5 97 09-211
Fax: +49 221 5 97 09-898
Fault Cause
• Awning automat- • Wind alarm
ically retracts in
manual mode
• Poor radio connection
• No travel com- • Wind alarm is active
mand can be • Battery in the hand-held
issued via the transmitter is dead
hand-held trans- • Motor has no power
mitter supply or is overheated.
• Awning does not • Wind threshold value is
retract in windy set incorrectly
conditions • Wind vane is faulty
• Awning does not • Threshold set incor-
retract in windy rectly
conditions • Wind alarm is still active
• Manual mode is set
• Poor radio connection
• Light sensor is dirty
• "Light" threshold value
(OFF setting)
• Receiver does not • The BiSens SW-230 V
accept BiSens is already programmed.
SW-230V
info@weinor.de
We reserve the right to make technical changes
www.weinor.de
Remedy
• Wait for wind interlock
to be deactivated (15
minutes) or briefly inter-
rupt power supply.
• Change the position of
the BiSens SW-230V
• Wait (15 minutes)
• Change battery
• Check power supply
or allow motor to cool
down.
• Set correct value
• Replace
• Set correct value
• Wait
• Set automatic mode
• Change the position of
the BiSens SW-230V
• Clean light sensor
• Set appropriate level
• Delete BiSens SW-230V