Relay Play; Fader Start - Numark CDN22 MK5 Guide D'utilisation Rapide

RELAY PLAY

You can use CDN22 MK5's Relay Play feature to maintain a continuous flow of music between the two decks. When one deck's
track or CD is finished playing, the opposite deck will start playback. That deck will play until the track or disc is finished, then
the opposite deck will play again. Follow these steps to engage Relay Play:
1. Connect the included Relay Play cable to both AUTO-START CONNECTORS on the CDN22 MK5 control unit's
rear panel.
2. Insert CDs into both sides of the transport unit.
3. Press and hold the TIME buttons on both decks for 1-2 seconds until the LCD indicates "auto" and the track
number begins to flash. This means Relay Play is active.
4. If you want the decks to alternate playing individual tracks, press SGL on each deck until it enters Single Play Mode
("Single" should be displayed on the LCD).
If you want the decks to alternate playing whole CDs, press SGL on each deck until it enters Continuous Play Mode
("Single" should not be displayed on the LCD).
5. Press PLAY on either deck. When the track or CD reaches the end, the opposite deck will automatically begin
playback.
Note: You may also use Relay Play while in Program Mode (see PROGRAM under CD PLAYER FEATURES and LCD
FEATURES), but if your decks are in Single Play Mode ("Single" will display on the LCD) while in Program Mode, playback for
each deck will stop at the end of the last track in its program.

FADER START

You can use CDN22 MK5's fader start compatibility to start playback on a deck simply by crossfading to it on your remote mixer.
Similarly, crossfading away from a deck will cue that deck as though you had pressed the CUE button. (Your mixer must be
fader start-compatible for this to work.) Follow these steps to take advantage of CDN22 MK5's fader start feature:
1. Connect standard 1/8" mono cables from each AUTO-START CONNECTOR on the CDN22 MK5 control unit's rear
panel to its corresponding fader start input on your mixer.
2. Insert CDs into both sides of the transport unit.
3. Press and hold the TIME buttons on both decks for 1-2 seconds to activate CDN22 MK5's fader start capability.
4. Refer to your mixer's manual for how to use it with a fader start device.
7