LENCO DAR-251 Mode D'emploi page 9

BATTERY INSTALLATION
Battery must be inserted correctly to avoid damaging to the remote control. Always remove the
battery when the remote control will not be used for a long period of time, as this may cause
leakage of the battery and subsequently damage the remote.
Inserting the remote control batteries
1. Push the release clip on the battery compartment downwards and lift to remove the cover.
2. Insert 2 x 1.5 V AAA batteries (not supplied) the correct way around, by observing the polarity
(+ and -) indicated on the battery compartment.
3. Place the furthest end of the cover in position on top of the battery compartment. Then press the
nearest end of the cover until you hear it click firmly into place.
If the distance required between the remote control and the appliance decreases, the batteries are exhausted.
In this case replace the batteries with new ones.
Power
CAUTION
•
Risk of product damager! Make sure that the power voltage
corresponds to the voltage printed on the back label.
•
Risk of electric shock! When you unplug the AC power cord always pull
the plug from the socket. Never pull the cord
•
Before connecting the AC power cord, ensure you have completed all
other connections
Place the unit in the desired position and unravel the mains cable. Insert the cable into the supply
socket and switch on if applicable.
Auto standby
When playing media from a connected device, the device automatically switches to standby if:
•
No button is pressed for 10 minutes,
•
No audio from a connected device for 10 minutes.
Unit power supply (mains 230V/50Hz)
Connect the power cable plug to the (230V) wall outlet.
Warning:
•
Before using the unit, check that your local mains power is compatible with the unit: 230V (50Hz).
•
Do not plug or unplug the power cable when your hands are wet.
•
When planning not to use this unit for long periods of time (i.e., Vacation etc.), disconnect the plug
from the wall outlet.
- EN 9 -