Publicité
Les langues disponibles
Les langues disponibles
CONTROL BOARD
INSTRUCTIONS
PJEZ
1. Enter the Programming mode by pressing the
2. Released the keys, then push again the
immediately followed from the HY parameter.
NOW YOU ARE IN THE HIDDEN MENU.
3. Select the required parameter.
4. Press the
key to display its value
5. Use
to change its value.
6. Press
to store the new value and move to the following parameter.
To exit: Press
or wait 15s without pressing a key.
NOTE1: if no parameter is present in L1, after 3s the "nP" message is displayed. Keep the keys
pushed till the L2 message is displayed.
NOTE2: the set value is stored even when the procedure is exited by waiting the time-out to expire.
NCB Series: Control board instructions
To display target set point, in programming mode it selects a parameter
or confirms an operation.
To start a manual defrost
In programming mode it browses the parameter codes or increases the displayed value.
In programming mode it browses the parameter codes or decreases the displayed value.
keys for 3s (the "°C" or "°F" LED starts blinking).
keys for more than 7s. The L2 label will be displayed
New Air Refrigeration
.
9
Publicité
