New Air NCB-036-SS Manuel D'instructions page 8

INSTALLATION
& OPERATION
OPERATION
Set Temperature:
Push the SET key for more than 2 seconds to change the Set point value; The value of the set
point will be displayed and the "°C" or "°F" LED starts blinking. To change the Set value push
the o or n arrows within 10s.To memorize the new set point value push the SET key again or
wait 10s.
Temperature controller: After turning on for the delay time(2 minute), the compressor starts
when cold room temperature ≥set temperature + hysteresis, and will be off when cold room
temperature ≤set temperature. To protect the compressor, it can re-start unless the time when
the compressor stops every time is longer than the delay time.(2 minute)
CAUTION—Setting the temperature control to the coldest setting may cause the eventually result
in a warmer cabinet temperature.
ATTENTION!
The following are normal, not issues with the unit:
• A light sound of water flow in the cabinet.
• Heat from the compressor or condenser.
• If the ambient humidity is high, condensation may form on the doors. Simply wipe it off with a
cloth.
8
New Air Refrigeration NCB Series: Installation & Operation