Publicité
Les langues disponibles
Les langues disponibles
1
B
A
2.
Push the speed switch (3) to the desired
operating speed. Push the speed switch to
position A for low speed or position B for high
speed.
9.2
STOP THE MACHINE
1.
Release the trigger to stop the machine.
9.3
ADJUST THE LENGTH OF THE CUTTING
LINE
While you operate the machine, the cutting line gets
worn shorter. You can adjust the length of the cutting
line.
1.
Hit the trimmer head against the ground while you
operate the machine.
2.
Line is automatically released and the cut-off
blade cuts the excess length.
English
2
3
9
9.4
ADJUST THE CUTTING DIAMETER
The machine is set at a 14 in. (35.6 cm) cutting
diameter. You can adjust to a 16 in. (40.6 cm) cutting
diameter.
Set the cutting diameter to 14 in. (35.6 cm) for
greater runtime and 16 in. (40.6 cm)for a larger
cutting area.
1.
Remove the battery pack.
2.
Remove the blade screws from the cut-off blade.
3.
Turn the cut-off blade 180°.
4.
Tighten the blade screws.
9.5
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade
(17) on the guard. The line cut off blade continuously
trims the line to ensure a consistent and efficient cut
diameter. Advance line whenever you hear the motor
running faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep line long enough to advance properly.
9.6
OPERATION TIPS
WARNING
Keep clearance between the body and the machine.
WARNING
Do not operate the machine without guard in place.
Do these tips when you use the machine
• Keep a firm hold with the two hands on the machine
while the string head is spinning.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
NOTE
EN
Publicité
