Publicité
Les langues disponibles
Les langues disponibles
3.
Remove any remaining line.
4.
Clean dirt and debris from all parts. Replace
spool (2) if it is worn or damaged.
4
5.
Push the tabs and install the spool cover onto the
spool housing (3).
6.
Push the spool cover until it clicks into position.
10.4 INSTALL THE CUTTING LINE
Do not put more than 15 feet of cutting line in at a
time.
1.
Remove the remaining cutting line on the spool.
English
1
2
3
NOTE
2.
Line up the slots on the spool cap with the slots
on the trimmer head.
Spool
cover
3.
Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
Hole
4.
Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5.
Turn the spool cap clockwise to wind the cutting
line into the trimmer head. Keep approximately 5
in of cutting line above out of each side of the
trimmer head.
11
EN
Slots
Bump
head
Publicité
