Publicité
Les langues disponibles
Les langues disponibles
3
Prepare keypad and mounting plate (only for doors with smaller holes)
Diameter is 2-1/8" (54 mm)
2-1/8"
54 mm
No adjustment is required.
4
Install exterior assembly
A
Install the cylinder into the exterior assembly.
D
IMPORTANT: Make sure the torque
blade is in the horizontal position.
horizontal
G
Secure the mounting plate with the supplied screws.
Keep
parallel to
door edge.
M (2x)
What is the diameter of the hole in the door?
Proceed to step 4.
B
Route the cable below the latch.
E
D
E
Insert the torque blade through the
horizontal slot in the latch.
horizontal
slot
H
Insert the key and test the latch for smooth operation.
If latch does
not operate
smoothly,
adjust screws.
Diameter is 1-1/2" (38 mm)
or
A
Remove adapter ring from exterior assembly:
E
1. Remove gasket.
B
Use pliers to remove two tabs from mounting plate:
tabs
G
exterior side
of door
cable
F
2 / 4
1-1/2"
38 mm
2. Remove adapter
3. Reinstall gasket,
ring from gasket.
ensuring tight seal.
C
IMPORTANT: Make sure the latch is fully
retracted (in the unlocked position).
unlocked
F
Push the torque blade through the center
hole in the mounting plate and send the
cable through the bottom hole.
interior side of door
torque blade in
center hole
cable in
bottom hole
I
Remove the key and make sure the latch
bolt is still in the unlocked position.
G
unlocked
Publicité
