Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the front cover of the transmitter and receiver by undoing the
housing screw.
2.
Loosen the base-plates by undoing the fixing screw and remove it
3.
You now have two ways of fixing the connection cable to the rear side.
a.) Guide the connection cable through the cable guide on the base-plate.
b.) Guide the connection cable through the cable guide of the detector. To
do this, remove the predetermined breaking point from the rear of the
detector to guide the connection cable through.
4.
Now break out the opening for the cable guides on the rear of the
transmitter and receiver and connect the cables to the correct connectors.
5.
Screw the base-plates to the desired installation locations.
6.
Screw the transmitter and receiver to the nase-plates.
7.
After connecting the cables to the connectors, go to the "Putting into
operation" section.
6.5
Pole mounting
1.
Use a pole with a diameter of 38-45 mm.
2.
Remove the screwed base-plates of the transmitter and receiver.
3.
Screw 2 screws M4x20 into the screw-threads of the mounting brackets.
4.
Fix the mounting brackets to the masts.
5.
Screw the mounting plate with 3 screws M4x10 tightly to the base-plates of
the transmitter and receiver.
6.
Fix the mounting plates to the mounting brackets.
7.
Repeat steps 3–7 of "Wall mounting".
7.
Putting into operation
Before aligning the photoelctric beam, connect the power supply.
You can also connect up the alarm and tamper lines after alignment.
15
Publicité
