Publicité
Les langues disponibles
Les langues disponibles
7.8 The Buzzer (Zoemer)
function
When the buzzer function is activated
you can hear the buzzer at the:
• cycle end
• anti-crease phase start and end
• cycle interruption
The buzzer function is by default always
on. You can use this function to activate
or deactivate the sound.
7.9 The Time Drying (Tijd)
function
Operates only with the Time (Tijd) pro-
gramme. Lets the user to set special
time of drying programme from mini-
mum 10 min. to maximum of 2 hours (in
10 min. steps).
7.10 The Delay Start
(Startuitstel) function
Let to delay the start of a drying
programme from minimum of 30
minutes to maximum of 20 hours.
1.
Set the drying programme and func-
tions.
2.
Push the Delay Start (Startuitstel)
button again and again until the
necessary time of the delay come in-
to the view on the display (e.g.
if the programme has to start after
12 hours.)
3.
To activate the Delay Start (Startuit-
stel) function, push the Start/Pause
button. The time to start decreases
on the display.
7.11 Starting a programme
To activate the programme push the
Start/Pause button. The LED above the
push button changes the color to red.
7.12 Change a programme
To change a programme, turn the pro-
gramme selector to Stop and then set
the programme again.
7.13 Child lock function
The child lock can be set to prevent the
children to play with the appliance. The
child lock function locks all push buttons
and the programme dial (this function
does not lock On/Off (Aan/Uit) button).
To activate the child lock function push
the Time Drying (Tijd) and Delay Start
(Startuitstel) buttons at the same time
until the symbol
the display. To deactivate push again
the above buttons until the symbol go
out of view.
You can activate the child lock function:
• before you push the Start/Pause but-
ton - the appliance cannot start
• after you push the Start/Pause button
- all the push buttons and the pro-
gramme dial are deactivated
7.14 At the end of programme
When the drying cycle is completed, the
symbol flashes on the display. If the
Buzzer (Zoemer) function is on, an acous-
tic signal sounds intermittently for one
minute.
To remove the laundry:
1.
Push the On/Off (Aan/Uit) button for
2 seconds to deactivate the appli-
ance.
2.
Open the appliance door.
3.
Remove the laundry.
4.
Close the appliance door.
After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
ENGLISH
75
come into view on
Publicité
