Beamz 151.200 Manuel D'instructions page 4

CONTROLLER
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
DMX ADDRESSING
The controller of this LED curtain use 8 DMX channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DMX starting address via the
control board.
The DMX starting address is defined as the first channel from which the device will respond to the controller. Please make sure
that you do not have any overlapping DMX channels in order to control each device correctly and independently. If several units
are defined on one DMX address, they will work synchronously.
DMX SETTING
Channel Function
1 Master Dimmer
2 LED Red or ¼ cool white
3
LED Green or ¼ cool white
4 LED Blue or ¼ cool white
5
LED White or ¼ cool white
6
Strobe
7 Mode
8
Speed
MENU
Use to access the menu or return a previous menu option.
UP
Navigates upwards through the menu list and increases the value when in a
function.
DOWN
Navigates downwards through the menu list and decreases the value when
in a function.
ENTER
Used to select and store the current menu or confirm the current function
value or option within a menu
Value Description
000-255 Dimming 0-100%
000-255 Dimming 0-100%
000-255
Dimming 0-100%
000-255 Dimming 0-100%
000-255
Dimming 0-100%
000-003 No strobe
004-255 Strobe (slow-fast)
000-050 Manual control CH1-6
051-200
Auto mode
201-255 Sound mode
000-255
Auto mode speed
4