ARDES AR076A Mode D'emploi page 6

The heat perception may decrease if the user falls asleep.
For this reason, to avoid burns:
- do not use the appliance if the user might fall asleep
- do not lie down with the appliance in the bed
The temperature will reach its maximum value a few minutes after that the appliance has been unplugged from the
power socket.
To recharge the appliance, simply connect it again to the power socket once it has cooled down completely.
IMPORTANT NOTE: the perception of heat varies from person to person. If the temperature is too high for
you after the charge period, do not use the appliance and allow it to cool; for successive use, lower the charging
temperature by disconnecting the power cable from the socket before the LED turns off: the shorter the charging
time, the lower the temperature.
With a full charge cycle, if used covered (for example in bed) with its casing, the device remains heated for
approximately 6 hours; if left uncovered at room temperature, the device remains heated for about 4 hours.
Disconnect the plug from the socket and let the appliance cool down well before cleaning it.
Frequently examine the appliance to make sure there are no signs of wear or deterioration.
If there are such signs or if the appliance has been used improperly, bring it to an authorized service center before
using it.
This appliance does not require any special maintenance.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from entering into the appliance and irreparably
damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Bag (only for model AR076A - ARAM076)
Clean the bag (3) following the indications given on the special label applied to the inner part of the appliance.
6
Maintenance
NOT WASH