Publicité
Les langues disponibles
Les langues disponibles
SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come
into contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 21)
Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil.
•
First loosen handle lock lever.
•
Handle can be positioned at different settings between
"HIGH" and "LOW" positions.
•
Retighten handle lock lever securely after adjusting.
HANDLE
(LOW POSITION)
TIRE CARE
CAUTION: When mounting tires, un-
less beads are seated, over in fla tion
can cause an explosion.
•
Maintain 20 pounds of tire pressure. If tire pressures
are not equal, tiller will pull to one side.
•
Keep tires free of gasoline or oil which can damage
rubber.
TO REMOVE WHEEL (See Fig. 22)
•
Place blocks under trans mis sion to keep tiller from
tipping.
•
Remove hairpin clip and clevis pin from wheel.
•
Remove wheel and tire.
•
Repair tire and reassemble.
HANDLE
(HIGH POSITION)
HANDLE
LEVER
Fig. 21
TO REMOVE BELT GUARD (See Fig. 23)
LOCK
NOTE: For ease of removal, remove hairpin clip and clevis
pin from left wheel. Pull wheel out from tiller about 1 inch.
•
Remove two (2) screws from side of belt guard.
•
Remove hex nut and washer from bottom of belt guard
(located behind wheel).
•
Pull belt guard out and away from unit.
•
Replace belt guard by reversing above procedure.
SCREW
AND
WASHER
16
CLEVIS PIN
HAIRPIN CLIP
Fig. 22
BELT
SCREW AND
GUARD
WASHER
WASHER
(LOCATED
HAIRPIN
CLIP AND CLEVIS PIN
Fig. 23
HEX
NUT
AND
BEHIND
TIRE)
Publicité
