NORDFOREST 1800 Mode D'emploi page 98

Fault
Capstan winch does
not start
Capstan winch does
not pull load
900012 Rev. 01 | 09.2017
Cause
Tank empty
On/off switch defective
Manually-operated turning
gear defective
Spark plug damp
Very heavy encrustation of
the electrodes
Incorrect carburettor setting Adjusting the motor speed whilst idling
Too much oil in the petrol
mixture
Poor quality petrol mixture
Motor "flooded"
start-up
Rope slips
– Incorrect pulling rope
– Lubricant (oil, grease on
the capstan drum)
Capstan drum blocked
– Gear not engaged
– Transmission defective
Remedy
Filling the tank
Repair by repair workshop
Inspecting the spark plug
Replacing the spark plug
Replacing the spark plug
Adjusting the motor speed in the half-
throttle position
Empty tank
Empty tank
during Clean spark plug and start again after
approx. 20 min (see Page 77)
Draw on more rope windings, see
"Drawing in the pulling rope"
Replacing the pulling rope
Cleaning the pulling rope
Cleaning the capstan winch
Changing gear (capstan winch 1800)
Repair by repair workshop
Capstan winch 1800, 1200, 400
Faults
93