Publicité
Les langues disponibles
Les langues disponibles
Connections
Speaker Components
(L)
(R)
FRONT
STAND
(L)
(R)
STANDBASE
SURROUND
Installing the Speakers on the Tallboy Stand
1.
Turn the Stand Base upside-down and connect it to
the Stand.
2.
Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
3.
Connect the upper Speaker to the assembled Stand.
4.
Insert another large screw (5*15, For connecting Speaker
& Stand) clockwise into the hole on the rear of the
speaker using a screwdriver.
5.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
1
English
All manuals and user guides at all-guides.com
Assembled Speakers
SPEAKERCABLE
SCREW (5×15): 4EA
SCREW (4×20): 16EA
CENTER
FRONT/SURROUND SPEAKER
SUBWOOFER
Center SPEAKER
SUBWOOFER
1
2
Stand
Base
Stand
3
4
Speaker
Stand
5
Publicité
