SUHNER ABRASIVE SP 500 Hook Dossier Technique page 20

1. n
1.1 g
enerAl sAfety informAtions
This operation manual is applicable for the machine SP
500 Hook. The machine may only be handled by person-
nel who are qualified. Suitable safety and hygiene meas-
ures must be taken.
It is imperative that you observe the safety instruc-
tions provided separately.
The working environment must be kept clean and
well illuminated. Keep away persons in the vicinity when
you are using the hand piece. Wear tight fitting clothing
and secure long hair.
V
ery shArP BlAde
Use only food grade (FDA approved) lubricants,
e.g. TURBO LUBE GREASE (Art.-Nr. 60000078),
TURBO LUBE SPRAY (Art.-Nr. 60000077). Do not
place the nose on a hard surface, but only in the provided
receiver.
1.2 u
se of the mAchine for PurPoses for
which it is intended
These machine is designed to process rough cut meat on
an industrial scale. It can be used to remove fat, tissue,
bones, and other small parts and to detach meat from
other animal parts.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner AG of Industriestrasse 10, CH-5242 Lupfig,
hereby declares under sole responsibility that the product
with the serial or batch no. (see reverse side) complies
with the requirements under the Directive 2006/42/EG.
Applied standards: EN ISO 12100. Document Agent: T.
Fischer. CH-Lupfig, 10/2019. T. Fischer/Managing Division
manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Fitting of hose coupling.
(Inside diameter min. 4,5 mm, available as option-
al accessory. Hose connector: Item no. 908 051;
Hose clip: Item no 02789204)
20
s
otes on aFety
!
ommIssIonIng
Remove protective plug from air supply hose. Push hose
clip over air supply hose, insert hose nozzle in air supply
hose, and secure this with the hose clip. Observe national
regulations.
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
V
ery shArP BlAde
2.3 r
Ating dAtA
Pressure max.
Air quality DIN ISO 8573-21
Air consumption full load max.
Power output
No-load speed
Sound pressure level EN ISO 15744 72dB(A), K=3dB(A)
Vibration
Weight
2.4 o
PerAting conditions
Temperature range during operation: -7°C to +50°C
Relative air humidity: 95% at +10°C not condensed
!
6.3bar
3/5/4
3
0,38m /min
250W
-1
4500min
<2,5m/s
0,685kg