Télécharger Imprimer la page

Bestron SUMMER BREEZE ASV45W Manuel D'instructions page 17

Masquer les pouces Voir aussi pour SUMMER BREEZE ASV45W:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 7
OPERATION - General information
The description below corresponds to figure 1 on page 2.
1. Fan blades
2. Fan housing
3. Motor housing
4. Swivel button
5. Control unit
6. Stop button
MONTAGE - Assembling the stand
The description below corresponds to figure 2 on page 2.
1. Lay the two feet of the stand across each other, at right angles, and fit them to the upright using the four
screws.
2. Remove the height lock from the upright.
3. Slide the protective cover onto the upright, and fit it over the feet.
4. Fit the height lock to the upright.
MONTAGE - Assembling the fan
The description below corresponds to figure 3 on page 2.
1. Unscrew the locking ring (F) from the motor-housing (by turning it anticlockwise) and remove the ring
from the motor housing.
2. Fit the rear of the fan housing (B) onto the motor-housing, making sure that the openings are aligned
precisely with the lugs on the motor housing and that the grip is at the top.
3. Slide the locking ring onto the shaft, and screw it tight (clockwise).
4. Slide the fan blades onto the shaft, making sure that the notches are aligned precisely with the two keys
on the shaft.
5. Fit the spinner onto the shaft and tighten it (anticlockwise) whilst preventing the fan blades from moving.
6. The rim has five clamps (A). Carefully fit the rim around the rear half of the fan housing, making sure that
the housing falls into the upper clamp of the rim, so that you can connect the two halfs of the fan housing
with the nut and bolt (C). Use a crosshead screwdriver to screw the bolt into the nut.
7. Close the other clamps.
8. Loosen the stand lock fitted to the rear of the control unit.
9. Fit the fan onto to the upright, and tighten the lock.
OPERATION - Ventilate
The description below corresponds to figure 4 & 5 on page 2.
1. Set the fan on a level surface, such as a table. Adjust the stand to the required height, see Figure 4.
Loosen the height lock (by turning it anticlockwise). Adjust the stand to the required height and tighten
the height lock (by turning it clockwise).
2. Tilt the fan to the required angle (see figure 5). You can set the fan:
a. to blow horizontally (position a) or angled slightly downwards (position b). Tilt the ventilator housing
and motor housing to the required angle.
b. to oscillate from left to right (with a sweep of 75 °). This will ventilate much of the room. Press the
oscillation button on the motor housing fully in.
c. remain in the same position whilst the fan is turning. This will ventilate one area. Pull out the
oscillation button until you hear it click.
3. Put the plug into the wall socket.
4. Switch on the fan by pressing one of the three speed buttons.
a. Position '1', the fan operates at low speed.
b. Position '2', the fan operates at normal speed.
c. Position '3', the fan operates at high speed.
5. Stop the fan by pressing the stop button (position '0').
7. Speed buttons
8. Stand lock
9. Power cord and plug
10. Telescopic stand
11. Height lock
17
17
EN
EN

Publicité

loading