Bosch KGN86 Serie Manuel D'utilisation page 25

Disconnect the appliance from the
2.
power supply.
Unplug the appliance from the
mains or switch off the circuit
breaker in the fuse box.
Take out all of the food and store it
3.
in a cool place.
Place ice packs (if available) onto
the food.
Remove all fittings and accessor-
4.
ies from the appliance.
→ Page 25
Remove the shelf above the fruit
5.
and vegetable container.
→ Page 26
13.2 Cleaning the appliance
WARNING
Risk of electric shock!
An ingress of moisture can cause an
electric shock.
Do not use steam- or high-pres-
▶
sure cleaners to clean the appli-
ance.
Liquid in the lighting, controls or in-
ner ventilation openings can be dan-
gerous.
The rinsing water must not drip
▶
into the lighting, controls or inner
ventilation openings.
ATTENTION!
Unsuitable cleaning products may
damage the surfaces of the appli-
ance.
Do not use hard scouring pads or
▶
cleaning sponges.
Do not use harsh or abrasive de-
▶
tergents.
Do not use cleaning products with
▶
a high alcohol content.
Cleaning and servicing en
If you clean fittings and accessories
in the dishwasher, this may cause
them to become deformed or discol-
our.
Never clean fittings and accessory
▶
in the dishwasher.
Prepare the appliance for cleaning.
1.
→ Page 24
Clean the appliance, the fittings,
2.
the accessories and the door seals
with a dish cloth, lukewarm water
and a little pH-neutral washing-up
liquid.
Dry thoroughly with a soft, dry
3.
cloth.
Insert the fittings and install the ap-
4.
pliance components.
Electrically connect the appliance.
5.
→ Page 16
Putting the food into the appliance.
6.
13.3 Removing the fittings
If you want to clean the fittings thor-
oughly, remove these from your ap-
pliance.
Removing the shelf
Pull out and remove the shelf.
▶
→ Fig.
10
Removing door rack
Lift the door rack and remove it.
▶
→ Fig.
11
Removing pull-out containers
Lift the pull-out container and re-
▶
move it.
Removing the storage container
Pull out the storage container as
1.
far as it will go.
Lift the storage container at the
2.
front and remove it
→ Fig.
12
⁠ .
25