Hoover H-WASH 550 H5WPB610AMBC8-S Mode D'emploi page 74

Confirm by pressing the START/PAUSE

button.
Check the water hardness LEVEL of
your city at
company.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
To start the selected cycle with the preset

parameters, press START/PAUSE. When
the programme is running, the display will
show the time to elapse.
Moreover, If you want to modify the

chosen programme, press the desired
options buttons,
parameters and then press START/
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
 After switching on the appliance, wait a
few seconds for the programme to start
running.
PROGRAMME DURATION
When a programme is selected the

display automatically shows the cycle
duration, which can vary, depending on
the options selected.
Once the programme has started you will

be kept informed constantly of the time
remaining to the end of the wash.
The appliance calculates the time to the

end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to that
applicable to the size and composition of
the load.
PROGRAMME END
When the display

programme is finished and the DOOR
LOCKED indicator light has gone out, the
door can be opened.
your water supply
modify the default
shows that
 At the end of the cycle, switch off the
appliance by turning the selector to OFF.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
PAUSING THE MACHINE
While a cycle is running, the machine can

be paused by simply pressing the
START/PAUSE button.
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
Press the START/PAUSE button again to

re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, set the

selector to the OFF position.
Wait until the DOOR LOCKED light has

gone out before opening the door.
TEMPERATURE SELECTION
button
 This button allows you to change the
temperature of the wash cycles.
It is not possible to raise the temperature

over the maximum allowed for the
programme, in order to protect the
the
fabrics.
If you want carry out a cold wash all the

indicators must be off.
74