Hoover H-WASH 550 H5WPB610AMBC8-S Mode D'emploi page 71

6. REMOTE CONTROL (WI-FI)
This appliance is equipped with Wi-Fi
technology that allows you to control it
remotely via App.
APPLIANCE PAIRING (ON APP)
Download the hOn App on your device by

framing the following QR code:
or by the link:
go.haier-europe.com/download-app
The App is available for devices
running both Android and iOS, both
for tablets and for smartphones.
Get all the details
functions by browsing the App in
DEMO mode.
The frequency of the home Wi-Fi network
has to be set on the 2.4 GHz band. You
can not configure the machine if your
home network is set to the 5 GHz band.
 Open the App, create the user profile (or
log-in if it is already created previously)
and pairing the appliance following the
instructions on the device display.
TO ENABLE REMOTE CONTROL
 Check that the router is switched on and
connected to the Internet.
Load the laundry, close the door, add the

detergent if it's necessary.
Turn the programme selector to the

REMOTE CONTROL (Wi-Fi) position
the door will lock and the controls on the
control panel will be disabled.

TO DISABLE REMOTE CONTROL

of the Wi-Fi

:
71
Start the cycle using the app. When the
cycle has been completed, turn off the
machine by turning the programme
selector to the OFF position to unlock the
door.
To exit REMOTE CONTROL mode while
a cycle is underway, turn the programme
selector to any position other than
REMOTE CONTROL (Wi-Fi), without
going through the OFF. The control
panel on the appliance will be operative
once again, and if the cycle is paused,
you will be able to open the door once the
DOOR LOCKED indicator light switches
off.
For safety reasons, in some wash
cycle phases, the door can be
opened only if the level of the water
is below its lower edge and if the
temperature is less than 45°C. If
these conditions are met, wait for the
DOOR LOCKED light to switch off
before opening the door.
With the door closed, turn the knob to the
REMOTE CONTROL (Wi-Fi) position to
control the appliance using the app once
again. If there is a cycle underway, it will
continue.