Garland XTRIM 365 RE Manuel D'instructions page 25

sure that no people or animals come near the work
area.
When the work must be performed simultaneously by
two or more persons, always check the position and
location of each other in order to keep a safe distance
between eachother.
Keep the work area clean and work with good lighting.
Only use this machine in daylight or adequate artificial
lighting. Cluttered and dark spaces cause accidents.
Inspect and remove any objects that can cause
damage to you or to the machine.
Inspect your work area and remove all stones, wood,
wires, and foreign objects which might come into
contact with the cutting tool.
2.4. ELECTRICAL SECURITY
This device must only be connected to alternating
current of 230V/50 Hz.
Do not expose the machine to rain or
moisture. Contact with water will increase
the risk of electric shock.
Never cut the cable. This risks electric shock and
damaging the machine.
The electrical plug of this machine must match the
base of the socket. Do not modify any plugs in any
way. Unmodified pins and matching bases reduce the
risk of electric shock.
When using this machine, avoid contact
with things like metal fences, pipes, etc.
that are connected to land. Contact with
these things increases the risk of electric shock.
Do not touch the cords and plugs with wet hands.
Do not abuse the cord. Do not use the cable to carry,
lift or unplug the machine. Keep the cord away from
heat, oil, sharp edges or parts in motion. Damaged or
entangled cords increase the risk of electric shock.
Never use this machine with the cable or the plug
damaged. Before connecting the machine, check the
plug for damage. If you discover any problems send
your machine to an authorized repair shop. If the
cord is damaged or broken, unplug it immediately. A
damaged or entangled power cord increases the risk
of electric shock.
The replacement of the plug or the power cord or any
type of technical assistance must always be done by
the manufacturer.
It is recommended to connect this machine to a
device with a current less than or equal to 30mA. You
must verify this before using the machine.
Never use a damaged connection; this does not
comply with the rules or requirements for this
machine
When using an extension cable, make sure it has a
minimum section of 1.5 mm
always fully unrolled, and is suitable for outdoor use.
The use of an extension cable suitable for outdoor use
reduces the risk of electric shock
Place the extension cord so that it does not snag on
branches or obstacles and in a way that does not
interfere with the work area. The extension cord must
always be behind the operator.
Always position the extension cord on the hook that
exists on the machine.
Keep the cord always away from the blade.
25/104
English
2
, not more than 25 m,