Publicité
Les langues disponibles
Les langues disponibles
Figure 3
LADDER RACK INSTALLATION (with Zero RU Mounting Bracket Kit #5WMNB-ACC)
1) Determine target location for mounting.
2) Install one mounting bracket each at the two corners using the #8 screws and washers provided in the mounting
bracket kit. (Figure 4)
3) Hang the assembled unit over the ladder rack side rail as shown in Figure 5.
Figure 4
STACKING MULTIPLE UNITS
Up to three units can be joined and mounted together. Quantity (2) #8 x ¼" machine thread screws (Not Provided) are required
for stacking one enclosure to another. A maximum of three stacked Mini Enclosures is recommended.
1) Determine target location for mounting.
2) If passing cable from one enclosure to another, remove the metal knock-out tabs on the door of the rear-most enclosure
(Enclosure #1) and the base of the top enclosure (Enclosure #2) before mounting.
openings in the base of Enclosure #2.
5) Install #8 screws through the base of Enclosure #2 into the threaded receiving holes in the cover of Enclosure #1 and secure
to hand tightened torque.
NOTE: Installation of Edge Guard protective material is recommended when routing cable from one stacked enclosure to
another. Edge guard material should install to a thickness range of 0.113" to 0.130".
Page 6 of 30
Figure 5
DI-000-5WMNT-20C
Publicité
