Publicité
Les langues disponibles
Les langues disponibles
Problem
Possible reasons
The inner pressure exceeds working
pressure, or the inner pressure
exceeds the safety pressure.
Intense release of pressure
from the pressure limit valve.
The pressure limit valve is in an
incorrect position.
Faulty pressure control resulted in
release of pressure.
The inner pressure exceeds working
pressure, or the inner pressure
exceeds the safety pressure.
Residue in the float valve.
Continuous pressure release
from the float valve.
The float valve is stuck.
236
Solutions
Clean pressure limit valve, float
valve and lid thoroughly. If float
valve still has steam coming out,
please return appliance to the
nearest Approved Service Center for
inspecting, repairing or adjusting by
authorized person.
Carefully rotate/press the pressure
limit valve to make it fall into
place. Be careful of the hot steam.
Position yourself safely and wear
oven mitts.
Send the appliance to an Approved
Service Centre for repair.
Clean pressure limit valve, float
valve and lid thoroughly. If float
valve still has steam coming out,
please return appliance to the
nearest Approved Service Center for
inspecting, repairing or adjusting by
authorized person.
a. Press continuously the pressure
release button to remove the
pressure inside of the cooking
pot. It can take a few minutes
until the pressure is fully released.
b. Let the appliance cool down for
at least 2 hours.
c. Clean and dry off the float valve
before restarting the cooking.
a. Press continuously the pressure
release button to remove the
pressure inside of the cooking
pot. It can take a few minutes
until the pressure is fully released.
b. Let the appliance cool down for
at least 2 hours.
c. Clean and dry off the float valve
before restarting the cooking.
Problem
Possible reasons
The sealing gasket is not properly
installed.
The sealing gasket is dirty.
Steam leakage from lid.
The sealing gasket is damaged,
or the edge of the cooking pot is
damaged.
Solid/liquid ingredients ratio is
incorrect.
Food is uncooked
No electricity from the power
supply.
E0 displayed on the digital
Pressure switch is faulty.
screen.
E1 displayed on the digital
The temperature sensor is faulty.
screen.
The lid is not properly positioned
E2 displayed on the digital
for your cooking program. Each
screen.
program requires a specific lid
position.
Solutions
Remove the sealing gasket, clean
it and reinstall it in the correct
position.
Remove the sealing gasket, clean
it and reinstall it in the correct
position.
Send the appliance to an Approved
Service Centre for repair.
Try again by following precisely the
quantities of the recipe.
Check your home electric circuit.
Send the appliance to an Approved
Service Centre for repair.
Send the appliance to an Approved
Service Centre for repair.
Check and adjust the lid position
required by your cooking program,
refer to the cooking programs
table in part 6 of this manual.
Restart your program once the lid
is correctly positioned. If the issue
remains, send the appliance to an
EN
Approved Service Center for repair.
237
Publicité
