Télécharger Imprimer la page

BST LAB16DSP Manuel D'utilisation page 8

Publicité

Les langues disponibles

Les langues disponibles

LAB16DSP
DESCRIPTION
FRONT PANEL
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. MUTE BUTTON
11. CHANNEL LEVEL CONTROL
© Copyright LOTRONIC 2015
MIC INPUT
This balanced input is a XLR input.
Pin 1 = ground
Pin 2 = + ( Hot point )
Pin 3 = - ( Cold point )
This input can work with electret microphone ( See phantom button ).
Note : Switch the mixer off before to enable the phantom power.
LINE INPUT
The unbalanced mic input is provided for the use of an unbalance mic and is designed to accept an
unbalanced high impedance input signal.
This use for connection deck, turntable, keyboard,... )
Note : Do not connect XLR and Jack socket in the same time
GAIN CONTROL
Use to adjust sensitivity on finput signal from +15dB to -45dB.
REGLAGE NIVEAU AUX VOIE MONO
This button is normally derived after eq and channel fader ( POST FADER, POST EQ ), and is therefore
follow any changers in fader level. They are normally used to drive effects processing unit which are fed
back into the mixer and which must fader out with the input channel.
FX LEVEL CONTROL
Use to adjust the level of signal you to send to Digital effect processor.
HIGH TONE CONTROL
This control gives you up to 15db boost or cut at 12KHz and below. This circuit is flat ( no boost or cut ) at
center detent position.
MID TONE CONTROL
This control gives you up to 15db boost or cut at 2,5KHz and below. This circuit is flat ( no boost or cut ) at
center detent position.
LOW TONE CONTROL
This control gives you up to 15db boost or cut at 80Hz and below. This circuit is flat ( no boost or cut ) at
center detent position.
PAN CONTROL
The pan control sends continuously variable amounts of the post fader signal to either the left or right main
busses. In the center position, equal amount of signal are sent to the left and right busses.
All output from the channel are enabled when the mute switch released and muted when the switch is
down
This fader is used to adjust the volume of signal connection into each channel and adjust the volume of
output, together with master fader.
BSTDJ.COM
Page 8

Publicité

loading

Ce manuel est également adapté pour:

15-2766