Publicité
Les langues disponibles
Les langues disponibles
(2) Automatic White Balance Control Mode (AWC)
1. Move the cursor to WHITE BAL and select AWC →
PUSH SET with the joystick.
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET
2. Press the CAM (SET) button to start the white bal-
ance setup. PUSH SET is highlighted to indicate that
white balance is being set.
3. PUSH SET returns to normal when balance setting is
completed.
4. For fine adjustment of the AWC, move the cursor to
AWC and press the CAM (SET) button. The AWC
fine adjustment menu appears on the monitor
screen.
R
B
RET
5. Move the cursor to RET with the joystick and press
the CAM (SET) button to return to the SET UP menu.
G Motion Detector (MOTION DET)
1. Move the cursor to MOTION DET and select ON or
OFF with the joystick.
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET
2. If ON is selected, press the CAM (SET) button. The
MOTION DETECT menu appears.
You can mask the areas in this menu.
OFF
ALC
AUTO
ON(MID)
OFF
INT
AWC →PUSH SET
OFF
AUTO L
SPECIAL2
**
AWC
**
••••|••••
-
+
••••|••••
-
+
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
ON
AUTO L
SPECIAL2
3. Move the cursor to MASK SET and press the CAM
(SET) button. 48 mask areas appear on the monitor
screen.
Refer to Light Control Setting on page 43 for mask-
ing operations.
4. After masking areas, press the MON (ESC) button.
The MOTION DETECT menu appears on the monitor
screen.
5. Move the cursor to ALARM and select ON or OFF
with the joystick.
ON: The alarm signal is supplied while the display
mode is activated.
OFF: The alarm signal is not supplied while the dis-
play mode is activated.
6. Move the cursor to DISPLAY MODE.
Press the CAM (SET) button to see the present set-
ting. The areas that detect the motions blink.
7. Move the cursor to LEVEL with the joystick.
Obtain the optimum detection level with the joystick.
LEVEL
DWELL TIME
DISPLAY MODE
MASK SET
RECOVER TIME
RET
Note:
Repeat the above procedure until you obtain the
adjusted results.
8. Dwell Time
Move the cursor to DWELL TIME, and select a time
with the Joystick.
When the time specified here elapses after motion
detection, the camera will notify the connected
device of the alarm activation. The default setting is
2 seconds.
Selectable times (unit: s): 2S, 5S, 10S, 30S
9. Move the cursor to RECOVER TIME with the joystick.
You can select the following recover times. (unit:
min)
1MIN
2MIN
OFF
-47-
** MOTION DETECT **
••••|••••
-
+
2S
ALARM
OFF
1MIN
3MIN
5MIN
60MIN
30MIN
20MIN
10MIN
Publicité
