Bodum Calorius 5057 USA Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

POURING WATER
– To remove the kettle from the base (
body horizontally while lifting clear of the base unit (
– The spout cap (
– Pour water from the hole in the top cover (
NOTE: Please be careful when pouring water from the kettle as
boiling water may scald.
SWITCHING THE KETTLE ON AGAIN
– The kettle can be switched on again at any time when the kettle has been
turned off manually.
– You can switch the kettle on again provided the built-in thermal safety
switch has had enough time to cool down.
6
CONNECTING THE POWER SUPPLY
– After filling your kettle, place it on the base unit
(
), making sure that the body fits on the 360°
contact housing (
– Connect the power plug to the power supply and
push the ON/OFF lever (
NOTE: Ensure that the ON/OFF lever is clear
of obstructions and the cap is closed tightly.
SWITCHING OFF
– Your kettle is fitted with an ON / OFF switch which
automatically switches off once the water has
boiled.
– You can turn off the power by lifting the ON / OFF
lever (
) up at any time. The kettle can also be
switched off automatically by removing the kettle
body from the base at any time.
NOTE: The kettle can not be turned off
manually if the switch is obstructed or the
ON / OFF lever is held down.
) shall be removed before pouring.
) on the base unit (
) down.
), grasp the grip (
).
).
).
) and hold the

Publicité

Table des Matières
loading

Table des Matières