Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
CLEANING THE MULTI-SURFACE BRUSHROLL
THE BRUSHROLL NEEDS OCCASIONAL MAINTENANCE.
REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN. See sharkaccessories.com for replacement
parts.
Push up on the tabs on the brushroll access door,
then lift off the door.
Remove the blue cap on the end of the brushroll.
Do not let the metal cylinder inside the cap fall out.
Clean off any hair or debris, then replace cap. Clean
the brushroll periodically and whenever hair appears.
NOTE: If the metal cylinder falls out of the brushroll cap, reinsert it in the hole on the inside of the cap. When cutting
away debris, be sure not to cut the brushroll or any other parts of the robot.
s h a r kc l e a n . c o m
Lift out the brushroll.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down
until it clicks into place.
MAINTENANCE
CLEANING SENSORS AND CHARGING PADS
CLEAN SENSORS AND CHARGING PADS PERIODICALLY AS NEEDED. With a dry cloth or cleaning brush, gently dust off
the sensors and pads located on the bottom of the robot.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
CLEANING SIDE BRUSHES
CLEAN SIDE BRUSHES AS NEEDED. CHECK WEEKLY.
RECOMMENDED REPLACEMENT SCHEDULE: Replace when visibly worn. See sharkaccessories.com for replacement parts.
NOTE: Remove any side brushes that are bent or damaged. To remove a brush, lift it off its peg. See Installing the Side
Brushes for instructions on how to attach and remove the brushes.
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a damp cloth. Be sure to
let them air-dry completely before reinstalling them.
s h a r kc l e a n . c o m
Publicité
