Kanuk Original Serie Mode D'emploi page 140

KanUK DesIGn Heating moDe
Self-closing door design
The basic version of Kanuk Design LuTo is already equipped with a self-closing door. The mechanism is designed in
such a way that it remains open for reloading at an opening angle of 87°- 90°. If it falls below the 87° limit, the door
closes automatically, but does not lock. The proper functioning is guaranteed only when the LuTo stove is aligned in
balance. Kanuk Design Bank, Hang, Stand, Tower, Tube and Wave stoves do not have a self-closing door and cannot
be retrofitted.
Lock adjustment - Kanuk Design LuTo
EN
Over time, some parts of the kiln wear out and expand due to temperature fluctuations. In addition to the gasket,
this can also be the case on the metal. This may make it necessary to readjust the closure bolt.
Instructions
Unscrew the grub screw (1) using a long Allen wrench.
Loosen the handle (2) by turning it counterclockwise - now
you can also unscrew and screw in the locking bolt (3) to
adjust the contact pressure of the door against the furnace
front. Once you have found the correct position, fasten the
handle (2) and the grub screw (1) again. Always make sure
that the door closes tightly.
heatInG MODe
Bench, hang, stand, tower, tube, Wave:
Open the primary air damper and secondary air damper fully. For lighting, use firewood placed in a pyramid shape
over a lighting aid, place thin logs over it and light the fire. After kindling, you can load the Kanuk® Design stoves
with logs according to Table 2 (page 28).
Kanuk Design luto:
Open the primary air damper fully. For lighting, use firewood placed in a pyramid shape over a lighting aid. Place
thin logs on top and light the fire. After the fire has been lit, you can feed the Kanuk Design LuTo with logs according
to Table 2 (page 28). The ceramics used in the Kanuk Design LuTo are not yet burnt out when delivered and have a
relatively high liquid content. As a result, it is possible that the furnace will burn poorly or not develop a nice flame
pattern during the first heating processes. After the drying phase, the heating process and the flame pattern change
noticeably.
note: The Kanuk® Design ovens are coated with high-quality, heat-resistant paint. When the hot-air stoves are
first fired up, the burning-in of the paint may cause a slight build-up of steam and a nuisance odor. Therefore,
open doors and windows when heating up for the first time.
note: To protect the Kanuk® Design stove, you should make sure that the stove is moderately loaded with
firewood during start-up, so that the boiler steel can stretch steadily. Due to differences between ambient
temperature and temperature in the stove, cracking sounds may occur in the stove. These are normal expansion
phenomena that do not represent a defect in the product.
140 Kanuk GmbH • Obercunnersdorfer Str. 4 • 01774 Klingenberg