Kanuk Original Serie Mode D'emploi page 128

KanUK DesIGn imPortant information
table 1:
Value triple for the calculation of chimneys according to DIN EN 13384-2 of June 2015 Parts 1, 2 + 3. The values given
in the following were determined on the basis of DIN EN 13240:2005-10
Kanuk® Design
Nominal heat output kW
Efficiency %
Exhaust gas temperature °C
EN
Exhaust gas mass flow g/s
Minimum chimney draught Pa
CO concentration mg/m³
Dust mg/m³
Burning time min
The firebox door must only be operated with a glove for refueling.
table 2:
Performance data:
Kanuk® Design
Fuel consumption kg/h
max. log length cm
max. heatable space m³
max. fuel quantity kg
* depending on building substance, insulation, etc.
Errors, misprints and technical changes reserved.
Permissible fuels
Use only air-dry, natural logs with a length of approx. 35 cm and a circumference of approx. 25-35 cm as fuel. In ad-
dition, the water content should be less than 20 %. Do not use contaminated waste wood, never treated or plastic-
coated wood, chipboard, sawdust, wood chips, coal, coke or similar! Trash and waste are also not approved fuelling
materials. Logs should be stored dry for at least two years before you use them as fuel. Never put more than the
maximum amount of wood specified in Table 2 to avoid overheating the Kanuk® Design stoves.
Emissions
The Kanuk® Design stoves meet the requirements of the second stage of the BImSchV, as well as the Austrian stan-
dard §15a-B-VG and can be operated without restrictions or retrofitting.
Type plate
The type plate can be found on the back of the stove. It must not be removed, because it confirms the inspection of
the stove and is necessary for the acceptance, as well as annual inspection of the chimney sweep.
128
Bank, Hang, Stand, Tower, Tube, Wave
Bank, Hang, Stand, Tower, Tube, Wave
Kanuk GmbH • Obercunnersdorfer Str. 4 • 01774 Klingenberg
8
85
250
6,8
13
781
25
60
2,02
35
200
2,02
LuTo XV LuTo VIII
8 8
80 81
244 223
14,8 8,12
16 13
646 578
40 38
49 45
LuTo XV LuTo VIII
4,0 2,1
45 33
450 200
4,0 2,1