Chapin 60105 Manuel D'utilisation Et D'entretien page 3

SPRAYER COMPONENTS & USE INFORMATION
NOZZLE ASSEMBLY
Figure 1
Unscrew the nozzle cap (1) from the nozzle body
(3) with retaining nut (2) fastened tightly to the
elbow (5). Unscrew the retaining nut (2). Push
the nozzle body (3) with the nozzle gasket (4) out
of the retaining nut (2). To reinstall the nozzle,
reverse the above instructions.
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining
Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle hole and shaft hole. Push the straight side of
the R-clip (B) through the aligned hole as shown in figure 1 thru 3.
Figure 1
R Clip
Chapin Backpack Sprayer Operator's Manual - English
1. Poly
O-ring
Wand
Figure 2
Line up holes
2E
Nozzle Cap
2. Retaining
Nut
4. Nozzle
Gasket
5. Elbow
A. Pump
Shaft
Figure 3
Slide clip through holes
3. Nozzle
Body
Figure 1
Shut-off
Valve
B. R Clip
C. Pump Handle