Measure the recommended amount of liquid.
Carefully pour the liquid into the tank.
Rinse the measuring container with clean water.
Screw the cap back onto the sprayer, making sure it is
tightened securely.
Reinstall the battery pack.
Spray solutions may be premixed and poured into the
sprayer, using a funnel if needed.
NOTE: If using a measuring container or if using a funnel
to fill the tank, be sure to thoroughly clean and rinse these
items after use. If premixing the spray solution, rinse the
container used for mixing.
NOTICE:
It is important to thoroughly clean the unit after each use.
Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.
ADJUSTING THE CONE SPRAY NOZZLE
See Figure 11.
The cone spray nozzle can be adjusted from a stream to a
cone spray.
Remove the battery pack from the tool.
Loosen the nozzle for a stream.
Tighten the nozzle for a fan spray.
SPRAYING HOME-AND-GARDEN CHEMICALS
See Figure 12.
Install the battery pack into the tool.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any
maintenance.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
OPERATION
Depress the ON/OFF button to start the motor.
Aim the sprayer nozzle directly at the plants or objects
Squeeze the trigger to start the spray.
Release the trigger to stop the spray.
Always empty, clean, and drain the tank after every use
Thoroughly clean the chemical sprayer before storing or
When you are finished with the sprayer, thoroughly wash
OPERATING TIPS
Never point the spray end of the wand at yourself or
Avoid spraying on windy days. Spray can be accidentally
Never spray in the direction of people or animals; always
Especially in warmer weather, spray in the early morning
Never smoke, eat, or drink while operating the sprayer.
MAINTENANCE
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
10 — English
you wish to spray.
NOTE: Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing back
onto you.
as directed in the Maintenance section.
before switching to a different chemical. See Cleaning
the Unit later in this manual.
your hands and any area where skin has been exposed
to the spray.
others.
blown onto plants or objects that should not be sprayed.
spray downwind.
or late afternoon. Excessive heat can evaporate the spray
before it settles.
WARNING: