Livoo DOM483 Notice D'utilisation page 18

continuous steam by placing the iron in a vertical position or by putting steam knob (4) on
indicated on the thermostat knob, you can only use steam at the highest temperatures. If the selected
temperature is too low, water may drip onto the plate.
CONTINUOUS STEAM
The temperature knob is adjusted to the maximum
Start the steam switch and move the product
When the steam switch is turned on, the product remains stationary for 3 seconds and the steam is
recovered when the product is moved!
BURST OF STEAM
This function provides an extra amount of steam to remove stubborn wrinkles.
Press the burst button to generate a powerful burst of steam that can penetrate the fabrics and smooth the
most difficult and tough creases. Wait for a few seconds before pressing again
By pressing the burst button at intervals you can use also iron vertically (curtains, hung garments, etc.)
Warning: the shot-steam function can only be used at high temperatures. Stop the emission when the
plate temperature control light comes on, than start ironing again only after the light has gone off.
DRY IRONING
1. Connect the iron to a suitable mains supply outlet.
2. Ensure that the steam knob (4) is on position
3. Select the setting with temperature knob.
4. When the light turns off, the required temperature is reached. The iron is ready for use.
Spray Function
Make sure that there is water in the reservoir. Press the spray button (6) slowly (for a dense spray) or quickly
(for a vaporized spray)
CORDLESS USE
This item is usable both with and without cord.
1. Use the lock/release switch (10) to unlock the unit from the base.
2. The first heating up time is 55 seconds.
3. The iron can be used continues without cord for 30 seconds.
4. Put the iron back on the base, the recharging time is 20 seconds.
5. After recharging it can be used without cord for 30 seconds again for steam ironing and 3 minutes
for dry ironing.
6. Put the iron back on base, lock it using the lock/release switch.
7. With the base locked on the unit it can be used as a normal steam iron with cord.
We advise you to use the iron in the corded position if you intend to steam iron for a length of time and
when you apply numerous shots of steam, as this can cause the soleplate to cool down considerably.
.
9
position. As